Installation guide

1–Installation
Bringing Up the System For the First Time
D000140-001 D 1-53
Welcome to the <SWITCH> CLI. Type 'list' for the list of
commands.
6. To change the switch IP address enter:
setChassisIpAddr -h ipaddress -m netMask
where -h ipaddress is the new IP address in dotted decimal (i.e.,
xxx.xxx.xxx.xxx) format, and -m netMask is the new subnet mask in dotted
decimal (i.e., xxx.xxx.xxx.xxx) format.
7. To change the switch default gateway IP address enter:
setDefaultRoute -h ipaddress
where -h ipaddress is the new default gateway IP address in dotted
decimal (i.e., xxx.xxx.xxx.xxx) format.
8. To to exit the CLI enter:
logout
Updating the Management Module IP Addresses in a
Redundant Management Configuration (12800-040,
12800-120, 12800-180 and 12800-360)
Each management module must have a unique IP address that is different than
the chassis IP address of the switch. Therefore, a redundantly-managed switch
will have multiple unique IP addresses.The default IP addresses are:
12800-040
 Chassis: 192.168.100.9
 Management Module 201: 192.168.100.10
 Management Module 202: 192.168.100.11
12800-120
 Chassis: 192.168.100.9
 Management Module 207: 192.168.100.10
 Management Module 208: 192.168.100.11
12800-180
 Chassis: 192.168.100.9
 Management Module 211: 192.168.100.10
 Management Module 212: 192.168.100.11
12800-360
 Chassis: 192.168.100.9