Installation guide

1–Installation
12200/12300 Installation
1-8 D000140-001 D
2. Install eight (8) cage nuts into rack posts, two (2) cage nuts per post. Install
the mounting rails and fasten to cage nuts using six (6) M6 screws. Torque
screws to 30in-lb. Do not install two (2) screws in lower locations on
equipment installation side of the rack until the switch is installed in the rack.
Note the orientation of mounting rails in Figure 1-4.. The rails are shown
from the front side of the rack for 12300 or from the port side of the rack for
12200.
Figure 1-4. Installing the Rack Rails
3. Slide the switch into the mounting rails and fasten with M6 screws, one (1)
per side. Torque screws to 30in-lb.