Installation guide

D–FRU Replacement
QLogic 12800 Series
D-6 D000140-001 D
Power Supply Replacement
FRU part number:12800-PS01
Removal Procedures
1. Push the release latch to release the arm.
Figure D-4 .12800 Power Removal
2. Carefully pull the supply until it is disengaged from the chassis.
Replacement Procedures
1. Slide the power supply straight into the open slot until it engages with the
backplane connector.
2. Make sure the supply is operating and the AC OK and DC OK LEDs are
green.
NOTE:
These power supplies are to be used exclusively with the QLogic
12800-series QDR InfiniBand switches and are not intended to be sold
separately.