Installation guide

1–Installation
Bringing Up the System For the First Time
1-38 D000102-000 B
NOTE:
If using a serial port, skip to Step 6. Steps 2 through 5 are for those users
accessing the switch via Telnet or SSH. For the 12800 series, make certain
to connect to the SEEB serial port associated with the Master Management
Module (MM). These are:
• 12800-040: MM 201
• 12800-180: MM 211
• 12800-360: MM 227
2. Connect applicable serial cables to the RS-232/DB-9 ports of the switch.
Connect the other end to a workstation. If using a terminal emulation device,
the settings should be:
•8 data bits
•no parity bits
• 1 stop bit
• 57.6K baud
• Use VT100 emulation.
• Flow control = XON/XOFF
3. If using Telnet or SSH, access the switch with the following command:
open 192.168.100.9
4. The system prompts for a user name. In order to change the IP address and
default gateway, the user must be logged in as the administrator. At the prompt
enter:
admin
5. The system prompts for a password. At the prompt enter:
adminpass
The system responds with:
Welcome to the <SWITCH> CLI. Type 'list' for the list of
commands.
6. To change the switch IP address enter:
setChassisIpAddr -h ipaddress -m netMask
where -h ipaddress is the new IP address in dotted decimal (i.e.,
xxx.xxx.xxx.xxx) format, and -m netMask is the new subnet mask in dotted
decimal (i.e., xxx.xxx.xxx.xxx) format.
7. To change the switch default gateway IP address enter:
setDefaultRoute -h ipaddress