Installation guide

1–Installation
12800-360 Standard Rack Installation
1-30 D000102-000 B
Install the Front Mounting Bracket
Figure 1-26 Front Mounting Bracket
1. Install the Front bracket and fasten to the Top bracket with #10-32 screws.
There are 5 screws. Fasten the Front bracket to the rack rails with M6 screws.
NOTE:
M6 nut clips should be pre-installed in corresponding locations on the rack
rails before installing Front bracket.
NOTE:
Front bracket should be installed after cables on top of the chassis are
routed from the back of the rack, through the top troughs, over to the sides
and down to corresponding Leaf modules. Cables should be secured to the
side plates. Front bracket is installed by moving up the face of the chassis
until mounting holes line up with corresponding holes in the Top bracket.
When installed, the Front bracket supports weight of the cables on top of it.
If chassis to be shipped installed in a rack before cables are installed, Front
bracket to be installed for shipment. Once at customer site, Front bracket to
be removed for cable installation and then re-installed as directed.