Installation guide

1–Installation
12200/12300 Installation
D000102-000 B 1-7
12200/12300 Installation
This section describes the rack mounting instructions for the 12200 and 12300:
Management Module Installation
To install the management module in a 12200 switch, follow the steps below:
1. Remove the screw from the blank cover (see Figure 1-3). Place the screw to
the side to be reused.
Figure 1-3 Insert Management Module 1
2. Remove the blank cover and discard.
3. Insert the management module assembly (Figure 1-4) into the switch at the
pivot points.
NOTE:
This section applies to those users who have purchased a managed version
of the QLogic 12200. Users with an unmanaged 12200 can skip to the rack
mounting instructions.