Installation guide

Configuring a CLARiiON boot device
97
Configuring a Boot Device on an EMC Storage Array
13. When the QLogic banner is displayed (as shown in step 2), press
Ctrl-Q.
14. Once the Fast!UTIL loads, select the Configuration Settings
menu and press Enter.
15. From the Configuration Settings menu, select the Selectable
Boot Settings menu and press Enter.
16. From the Selectable Boot Settings menu, select Selectable Boot
Device and press ENTER to enable this option if it is not already
enabled.
17. Select Current Boot Node Name and press Enter.
The adapter will scan for attached storage devices and a list of the
available LUN(s) will be displayed. Select the CLARiiON port
WWN from which the host will boot and select the LUN to be
used as the boot device and press Enter.
Note: On CLARiiON storage arrays, the desired boot LUN is 000.
18. Press ESC in the Selectable Boot Settings menu to return to the
Configuration Settings menu.
19. Press ESC in the Configuration Settings menu to return to the
Options menu.
20. Select Save Changes and press Enter.
21. Press ESC to exit the Fast!UTIL menu.
22. Reboot the host.
Installing onto the EMC storage array with the QLogic v8.x-series driver
EMC supports specific kernel and driver versions when booting from
the SAN. Currently RHEL4, RHEL4 U1, RHEL4 U2, SLES9 SP1, and
SLES9 SP2 in the kernel driver do not contain an EMC-qualified
version of the QLogic v8.x-series driver. However, the default QLogic
driver integrated into both distributions may be used for the
operating system installation on an EMC storage array device.
When using the QLogic driver integrated into the distribution, there
isn't a requirement to create a driver diskette image.