Installation guide

70
EMC Host Connectivity with QLogic Fibre Channel and iSCSI (HBAs) and (CNAs) for the Linux Environment
Installing and Configuring the Linux Host with the QLogic Driver
2. Enter tar –xvf qioctl-install.tar
3. Enter qioctl-install –install
The following is an example of load IOCTL module on RHLE4 U5
and above with command:
modprobe -v qioctlmod
RPM packages needed for RHEL5
To run the SANsurfer installer under Redhat 5 Linux, if the default
install is selected, the following RPMs need to be installed:
compat-libstdc++-33-3.2.3-61.<arch>.rpm
libXp-1.0.0-8.<arch>.rpm
Note: On x86_64 make sure to load 32 bit libs.