Installation guide

Summary of installation steps
19
Installation Steps
5 Install the firmware.
There are two states:
• Wrong firmware The adapter firmware is part of the Linux driver
and cannot be altered..
Proceed to Step 6.
The adapter firmware is part of the Linux driver
and cannot be altered.
“Updating the QLogic CEE /Menlo firmware for
FCoE adapters” on page 82
Once corrected, proceed to Step 6.
• Correct firmware Proceed to Step 6. Proceed to Step 6.
6 Connect to the
storage.
“Zoning and connection planning in a fabric
environment” on page 84
“Zoning and connection planning in a fabric
environment” on page 84
7 Reconfigure the
device.
“Device reconfiguration procedures” on
page 105
“Device reconfiguration procedures” on
page 105
Table 1 Installation steps (page 2 of 2)
Step Instructions For Fibre Channel, refer to For Fibre Channel over Ethernet (FCoE),
refer to