User`s guide

6 – SANsurfer Control iX
Performing Diagnostics
IS0053302-00 7 PRELIMINARY 6-39
Q
3. The Save Crash Record dialog box displays (see figure 6-33).
Figure 6-33. Save Crash Record Dialog Box
4. Enter a name and location for the crash file. If you do not know the location,
click Browse to display a file selection dialog. Select or create the file. The
Save Crash Record dialog box re-displays.
5. Click Save. The crash file will be in saved. Send this file to QLogic technical
support.
6.7
Performing Diagnostics
6.7.1
Pinging a Target
Perform the following steps to ping a target:
1. Select an HBA in the HBA tree.
2. Click the Diagnostics tabbed page.
3. Click the Ping tab.
4. Enter an address in the IP fields. The IP addresses can be viewed on the Target
Settings tabbed page.
5. In the Number of Packets field, enter the number of packets you would like
send. Valid values are in the range 1–10000. The default is 1.
6. Click Start Testing. The packet being sent is displayed in the bottom left-hand
side of the screen. When the test is complete, the Ping Status dialog box
displays (see figure 6-34).
Figure 6-34. Ping Status Dialog Box