User`s guide

6 – SANsurfer Control iX

Configuring Targets

6-30 PRELIMINARY IS0053302-00 7

4. At the prompt, enter your password. The CHAP tabbed page displays (see

figure 6-25).

Figure 6-25. CHAP Tabbed Page

5. Select the Enable check box for the targets for which you want to use CHAP.

6. Enter the initiator name and secret you want to use in the Initiator Name and

Initiator Secret columns.

7. CHAP is now enabled; the target will use CHAP to authenticate the

QLA4010/4010C HBA. If you also want the QLA4010/4010C HBA (initiator) to

authenticate the target, perform the following steps:

a. Select the Bidi check box of the target you want to configure.

b. In the Target Table portion of the page, click the green plus sign (+) on the

right. A blank row displays.

c. Double-click the row in the Target Name column. Enter the target name,

which can be a maximum of 256 ASCII characters. This name must be

entered on the target side (Name) for bidirectional CHAP.

d. Double-click the row in the Target Secret column. Enter the target secret,

which can be a maximum of 100 ASCII characters. This target secret must

be entered on the target side (Password) for bidirectional CHAP.

e. Repeat steps a through d for each target you want to configure. If you want

to remove a target from the Target Table, click the row you want to remove,

then click the minus sign (–) on the right.