User`s guide

6 – SANsurfer Control iX
Configuring Targets
IS0053302-00 7 PRELIMINARY 6-27
Q
CAUTION!
The iSCSI port number defaults to 3260. Do not change this number
unless required by the configured target.
6.5.2
Configuring Specific Targets
To configure a specific iSCSI target, follow these steps:
1. Start SANsurfer Control iX, select your host and QLA4010/4010C HBA, then
click the Target Settings tab.
2. Click green plus sign on the right-hand side of the screen (see figure 6-14).
3. Double-click the IP Address column. Enter the IP address of the target to which
you want to connect.
4. Double-click the iSCSI Name column. Enter the iSCSI name of the target.
5. If you want to enable the target, select the check box in the Enable Target
column associated with the target. If this check box is not selected, the target
is visible, but not accessible, to the HBA.
6. If you want to bind the target to the HBA (the Auto-bind Discovered Targets
check box was not selected), select the box in the Bind column associated with
the target.
7. Enter other targets as desired.
8. If you want all of the targets to be restored when the HBA is reset, select the
Auto-discover targets (Rediscover on Save) check box.
9. If you want to change any of the configuration parameters, follow the
instructions in section 6.5.3.
10. Do one of the following:
a. Click Save. The QLA4010/4010C HBA does the following:
❑
Resets (reboots the HBA only) if you have made changes to the firmware
configuration parameters in section 6.6.1.
❑
Connects to the target
❑
Makes these new targets available on the SANsurfer Control iX Target
Settings tabbed page
b. Right-click the target and select Login/Save Device. Enter your password
at the prompt. The QLA4010 logs into (same as connects?)
to the specific
target and saves this configuration. Why would they do this instead of clicking
Save?
c. If you want to log out, then reconnect to the target, right-click the target and
select Logout/Reconnect. Enter your password at the prompt.