User`s guide

6 – SANsurfer Control iX

Configuring the QLA4010/4010C HBA

IS0053302-00 7 PRELIMINARY 6-23

3. Configure the HBA as described in the following sections. When configuration

is complete, click Save.

After configuring the QLA4010/4010C, you can configure targets (see section 6.5),

configure the firmware (see section 6.6), and run diagnostics (see section 6.7).

6.4.1

Setting the IP Address

There are two ways to set the IP address, as described in the following sections:

■

Automatically (through dynamic host configuration protocol (DHCP)) (see

section 6.4.1.1)

■

Manually (see section 6.4.1.2)

6.4.1.1

Setting the IP Address Automatically

To set the IP address automatically through DHCP, select the Obtain an IP address

automatically (DHCP) radio button.

6.4.1.2

Setting the IP Address Manually

To set the IP address manually, perform the following steps:

1. Select the Use the following IP address radio button.

2. Enter the IP address.

3. Enter the subnet mask.

4. Enter the gateway.

6.4.2

Setting the DNS Server Address

There are two ways to set the DNS server address, as described in the following

sections:

■

Automatically (through dynamic host configuration protocol (DHCP)) (see

section 6.4.2.1)

■

Manually (see section 6.4.2.2)

6.4.2.1

Setting the DNS Server Address Automatically

NOTE: You must select the Obtain an IP address automatically (DHCP) radio

button to set the DNS server address automatically.