User`s guide

6 – SANsurfer Control iX
Configuring the QLA4010/4010C HBA
6-22 PRELIMINARY IS0053302-00 7
Q
6.4
Configuring the QLA4010/4010C HBA
The following sections provide instructions on how to configure the QLA4010/4010C
HBA:
■
Setting the IP address (see section 6.4.1)
■
Setting the domain name system (DNS) server address (see section 6.4.2)
■
Enabling service locator protocol (SLP) (see section 6.4.3)
■
Enabling internet storage name service (iSNS) (see section 6.4.4)
NOTE: You must configure the QLA4010/4010C HBA before you can configure
targets, edit target and firmware configuration parameters, or perform a
firmware upgrade.
Perform the following steps to access the configuration options, located on the HBA
Options tabbed page.
1. Select an HBA in the HBA tree.
2. Click the HBA Options tab. The HBA Options tabbed page displays.
Figure 6-23. HBA Tabbed Page (Network)
a. Entering a name in the HBA Alias box is optional (the default is none).
b. Entering a name in the HBA iSCSI Name box is optional (the default is the
iSCSI standard).