User`s guide

6 – SANsurfer Control iX
Getting Started
6-6 PRELIMINARY IS0053302-00 7
Q
6.3
Getting Started
This section includes the procedures for starting the SANsurfer Control iX GUI,
exiting the SANsurfer Control iX GUI, and customizing the application options and
policies.
This section discusses:
■
Starting the SANsurfer Control iX GUI (see section 6.3.1)
■
SANsurfer Control iX main window (see section 6.3.2)
■
Exiting the SANsurfer Control iX GUI (see section 6.3.3)
■
Getting help (see section 6.3.4)
■
Setting SANsurfer Control iX security (see section 6.3.5)
6.3.1
Starting SANsurfer Control iX
The SANsurfer Control iX GUI startup procedures differ depending upon the
operating system. This section discusses starting the SANsurfer HBA Manager GUI
on the following systems:
■
Windows 2000 (see section 6.3.1.1)
■
Red Hat Linux (see section 6.3.1.2)
6.3.1.1
Starting SANsurfer Control iX on Windows 2000
In Windows 2000, do one of the following to start the SANsurfer Control iX
application. When done, the SANsurfer Control iX main window displays (see
section 6.3.2).
■
Double-click the SANsurfer Control iX icon on your desktop (if the icon was
created during installation) (see figure 6-7).
Figure 6-7. SANsurfer Control iX Icon
■
Click Start, select Programs, select the install group (the default is QLogic
Corporation), select SANsurfer Control iX, then click SANsurfer Control iX.
■
Click the Start button, click Run, and then do one of the following:
❑
Type in the name of SANsurfer Control iX (SANsurfer Control iX.EXE or
Install.EXE? (conflicting review comments)), including all the paths. Click OK.
❑
Click Browse, then select the program after finding it in the Browse dialog
box. Click Open.