User`s guide

3 – Windows 2000 Driver Installation
Installing the Driver
IS0053302-00 7 PRELIMINARY 3-3
Q
After all the standard devices have been loaded, press S to Specify Additional
Device. Go to step 5.
3. If you are booting from the Windows installation floppy disks, after the standard
devices have been detected and configured, press S to Specify Additional
Device.
4. Select Other and press ENTER.
5. Insert the QLogic driver disk created in section 3.3 and press ENTER.
6. Select the QLogic QLA4010 PCI iSCSI Adapter, then press ENTER.
7. Continue with standard installation procedure.
3.4.2
Adding the QLA4010/4010C HBA to the Existing OS
NOTE: The QLA4010 adapter is a multifunction device. When installed in a
plug-and-play system, Windows 2000 detects two functions for each
adapter: ethernet controller and network controller.
Perform the following steps to add the QL4010.SYS driver to an existing
Windows 2000 system:
1. Install the QLA4010/4010C HBA in the appropriate slot on your computer (see
section 2.1).
2. Restart or power up your computer. Log in as Administrator.
3. When your computer powers up, Windows 2000 detects the newly installed
device, then displays the Found New Hardware with Ethernet Controller
message. The Found New Hardware Wizard program is launched to begin
installing the QL4010NULL?
should be QLA4010.sys? driver for the
QLA4010/4010C HBA.
4. Click Next.
5. In the Install Hardware Device Drivers dialog box, select Search for a
suitable driver for my device (recommended). Click Next.
6. In the Locate Driver Files dialog box, Select specify a location. Click Next.
7. In the Copy manufacture's files from: dialog box, type or browse the path to
the QLogic driver directory. For example:
A:\
8. Click OK.
9. In the Driver Files Search Results dialog box, click Next.
10. In the Completing the Found New Hardware Wizard dialog box, click Finish.