Installation guide

2
Manually Installing the HBA Driver – Advanced Users
2-21
Planning, Miscellaneous Procedures, and Troubleshooting
http://h200005.www2.hp.com/bc/docs/support/SupportManual
/c00220357/c00220357.pdf
Upgrading to
Windows 2003 from
Windows 2000
Note the following if upgrading to Windows 2003:
◆ Upgrading from Windows 2000 - The Windows 2000 drivers may
be preserved while upgrading to Windows 2003. These SCSIPort
drivers (including the native Windows 2003 SCSIPort drivers) are
not supported by EMC for Windows 2003. You should obtain the
correct Windows 2003 drivers. Refer to Downloading Latest QLogic
Drivers/Firmware/BIOS files on page 1-2, and reinstall the drivers
after the upgrade is complete.
◆ Currently, to upgrade from Windows 2000 to Windows 2003, you
must first uninstall PowerPath. After upgrading the host, you can
reinstall an approved Windows 2003 version. Please refer to the
EMC PowerPath documentation for further details. You may
wish to disconnect your storage during the Windows upgrade,
and reconnect it after the approved Windows 2003 drivers have
been installed.