Installation guide

2
2-20
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Planning, Miscellaneous Procedures, and Troubleshooting
1. Boot the host (if necessary) with Windows 2000 or Windows 2003.
2. From the Windows taskbar, click Start > Run, then type
Compmgmt.msc and press Enter.
3. In the left pane of the Computer Management window, click the
Device Manager icon.
4. Double-click the SCSI & RAID Controllers icon.
5. Under SCSI & RAID Controllers, double-click the adapter you
wish to upgrade.
6. In the next window, click the Driver tab; then click Update
Driver.
7. Follow the update wizard until you are given the choice to
Display a list of the unknown drivers for this device so that you
can choose a specific driver. Click the button next to this choice;
then click Next.
8. In the Select a Driver window, click Have Disk.
9. Enter the path to the diskette containing the driver (A:\, for
example), or use the browse function to locate the driver; then
click OK.
10. Select the driver that is discovered and click Next.
11. In the next window, click Next.
12. If prompted, click Yes to continue the installation.
13. Click Finish to complete the installation.
14. If the system requests that you reboot the system and you have
other adapters to update, select NO; then click Close.
15. If the system again requests that you reboot the system and you
have other adapters to update, select NO; then click Close.
16. If you have other adapters to update, select the next adapter
under SCSI & RAID Controllers and repeat steps 6 through 15.
When all adapters have had their drivers updated, select Yes to
the reboot prompt.
For more information on connecting to a SAN and installing
drivers/firmware on HP Proliant BL p-Class server blades, see the
"how to" guide, Connecting ProLiant BL p-Class server blades to a
third party SAN, available at the website as follows: