Installation guide

2
2-10
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Planning, Miscellaneous Procedures, and Troubleshooting
After CHAP settings are made, click OK at the bottom of the Authen-
tication Configuration dialog, as shown in Figure 2-8 on page 2-9. To
save all target settings, click Save at the bottom of the SANsurfer
iSCSI HBA Manager, Target Settings tab, as shown in Figure 2-6 on
page 2-8. You will be prompted for the SANsurfer security password.
The default password is
config, but it can be changed.
After the settings are saved, SANsurfer resets the HBA, and if target
information was discovered properly, you will see active connections
listed on the SANsurfer iSCSI HBA Manager, Target Information
tab. Also, you can view active targets under the HBA in the left pane
as shown in Figure 2-9.
Figure 2-9 SANsurfer iSCSI HBA Manager, Information Tab
SANsurfer has other features that are useful in managing your iSCSI
storage configuration. Please refer to the QLogic SANsurfer docu-
mentation for more information about these additional features.