Installation guide
2
2-8
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Planning, Miscellaneous Procedures, and Troubleshooting
To configure your iSCSI targets, click the Target Settings tab from the
SANsurfer iSCSI HBA Manager dialog, as shown in Figure 2-6.
Figure 2-6 SANsurfer iSCSI HBA Manager, Target Settings Tab
To add your target, click the green “plus sign” on the right side of the
Target Settings tab to get the IP Address dialog, as shown
inFigure 2-7. Enter the IP address of your target port, and click OK.
Figure 2-7 SANsurfer iSCSI HBA Manager, Target Settings, IP Address Dialog