Installation guide

2
Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)
2-3
Planning, Miscellaneous Procedures, and Troubleshooting
Figure 2-1 SANsurfer iSCSI HBA Manager, Connect to Host
Click Connect in the upper left corner of the SANsurfer iSCSI HBA
Manager dialog to get the Connect to Host dialog, as shown in
Figure 2-1. You are asked which host to connect to. Assuming you
are running the software on the server with the HBA(s) installed,
keep the default name of localhost as the host name, and click Con-
nect.
On the SANsurfer iSCSI HBA Manager dialog, the left pane dis-
plays discovered iSCSI HBAs. Click on the desired HBA in order to
change its settings. The SANsurfer iSCSI HBA Manager dialog
defaults to the HBA Options tab. which is selected from the row of
tabs at the top, as shown in Figure 2-2 on page 2-4.
From the HBA Options, you can set the iSCSI HBA parameters
including IP address, subnet mask, and gateway. If an iSNS server is
being used for your iSCSI configuration follow the procedure for set-
ting up iSNS later in Configuring iSNS settings for QLA4010 on
page 2-4.