Installation guide

1
1-30
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Installation and Configuration
Figure 1-26 QLogic HBA Instances with Specific Firmware Version
Type q and press Enter to exit the QLogic EFI Utility.
At the EFI shell prompt, type drivers and press Enter. Note the
entries which reference "QLogic Fibre Channel Adapter" are similar
to the listing shown in .
Figure 1-27 QLogic Fibre Channel Drivers
Make note of the first two digits (referred to as the "driver handle") on
the line which references the "QLogic Fibre Channel Driver"; if
multiple HBAs are installed in the server, there will be multiple
entries, as shown in Figure 1-27. The order of the HBA instances
listed is the order in which they have been enumerated by the system;
note that this does not necessarily correspond to PCI slot numbering.
In this example, the two QLogic HBAs installed in the server are
using driver handles 5F and 60, respectively. Type
drvcfg and press
Enter.
Figure 1-28 Driver Handle Numbers