Installation guide

1
1-26
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Installation and Configuration
If the firmware is listed as a series of zeros, and "AUX" is listed next to
the firmware field at the top of the report (as shown in Figure 1-22),
this indicates the EFI boot code has not yet been installed on the
HBA(s). Proceed as follows:
Installing the EFI boot code driver and non-volatile RAM settings on the
HBA(s)
The EFI boot code driver must be loaded onto the HBA(s) in order to
be used by the EFI BIOS.
Type
efiutil all ew=qlNNNNef.bin, where NNNN refers to the
chipset version on the HBA (in the example shown in Figure 1-22 on
page 1-25, 2312 refers to the chipset present on QLA2340/QLA2342
HBAs) and press Enter.