Installation guide

1
Booting from the External Storage Array
1-25
Installation and Configuration
The directory listing should contain the QLogic EFI boot code/utility
which was downloaded to the media (as shown in Figure 1-21 on
page 1-24).
The files of importance will take the following form:
Type efiutil and press Enter.
Figure 1-22 Fibre Channel Card Efi Utility
The QLogic HBA(s) installed in the server will be listed (as shown in
Figure 1-22). Note the "firmware" version listed in the utility. If the
firmware is listed as a specific version (not a series of zeroes), and
"AUX" is not listed next to the firmware field at the top of the report
then the EFI driver and firmware have been loaded on the HBA(s);
proceed to the section immediately following Figure 1-26 on
page 1-30.
efiutil.efi
QLogic EFI utility for updating adapter
driver/firmware
efiaux.drv
EFI auxiliary driver (used by efiutil when EFI
drivers are not loaded)
qlNNNNef.bin
EFI driver image file; written to adapter flash
(where xxxx refers to the chipset used on the
HBA - in this example, “2312” refers to the
chipset present on QLA2340/QLA2342 HBAs)
qlNNNNfw.bin
Adapter firmware file, written to adapter flash
(where xxxx refers to the chipset used on the
HBA - in this example, “2312” refers to the
chipset present on QLA2340/QLA2342 HBAs)