Installation guide

1
1-24
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Installation and Configuration
Before loading the QLogic EFI boot code/driver to the HBA(s),
ensure that any old EFI boot code which may be loaded in the system
has been removed. Type drivers at the EFI shell prompt and press
Enter.
Look for any driver listings which reference "QLogic Fibre Channel
Adapter", similar to the listing shown in .
Figure 1-20 Reference to QLogic Fibre Channel Driver
If such a driver entry exists in the output, it should be removed before
installing the current driver. Make note of the first two digits on the
line which references the QLogic Fibre Channel Driver ("60" in the
example shown in Figure 1-20); this is the "driver handle". Type
"unload <driver handle>". For the example shown in Figure 1-20,
"unload 60" would be used to remove the EFI driver. The system will
prompt to "Unload Protocol Image (y/n)?"; type "y" and press Enter.
The existing QLogic EFI driver will now be removed.
Type dir and press Enter to list the contents of the directory. If the
directory contents are not consistent with what you expect, and don't
appear to contain the QLogic boot code/utility, the filesystem select
may not be correct. Verify the proper filesystem has been selected. If
the QLogic boot code/utility resides in a subdirectory, type cd
subdirectory and press Enter.
Figure 1-21 QLogic Directory