Installation guide

1-18

EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment

Installation and Configuration

Figure 1-12 Select Fibre Channel Device Window

If no entries appear at any target IDs, verify the following:

◆ If multiple HBAs are present, verify the HBA select in the BIOS

Utility is the same which currently provides the I/O path to the

storage (at this point, only one I/O path should be configured to

the boot LUN)

◆ For CLARiiON arrays, verify that the single I/O path points to

the SP which owns the boot LUN

◆ For FC-SW environments, verify fabric zoning parameters, such

that a single I/O path exists to the boot LUN (see array software

documentation for details)

◆ Check physical FC connectivity between the HBA and array

(direct attach environment) or switch (FC-SW environment)

Select the array port to be used for boot, and press Enter. If LUNs

have been allocated to the HBA (using LUN Masking schemes, such

as Access Logix or Volume Logix), they will be presented at their

LUN number.