Installation guide

1
Booting from the External Storage Array
1-17
Installation and Configuration
Figure 1-11 Selectable Boot Settings Window
Selectable Boot is Disabled by default. Select this setting and press
Enter to enable Selectable Boot.
Scroll down to the (Primary) Boot Port Name, LUN: setting, and
press Enter.
The Fast!UTIL will now scan for attached FC devices (as shown in
Figure 1-12 on page 1-18). If physical connectivity to the array is
setup properly via zoning, then the array port will be found after this
scan. Use the <PageUp> and <PageDown> keys to navigate the list
of target IDs for the array port being used for boot.