Installation guide

1
1-14
EMC Fibre Channel and iSCSI with QLogic HBAs in the Windows Environment
Installation and Configuration
Legacy (x86 and most EM64T-based servers) boot BIOS configuration
During Power-On Self Test (POST), the QLogic banner will be
displayed. Press
CTRL+Q to enter the Configuration utility:
Figure 1-6 QLogic Banner
Select the HBA (enumerated by its I/O address) which will be used
for boot. If multiple HBAs are installed, there will be multiple HBA
entries. The order of the HBA instances listed is the order they will be
scanned for a boot device; note that this does not necessarily
correspond to PCI slot numbering), and press Enter.