Product guide
Table Of Contents
- Installing and Configuring the HBA and Driver
- Configuring a Boot Device on the EMC Storage Array
Configuring a Symmetrix boot device
51
Configuring a Boot Device on the EMC Storage Array
c. At the OK> prompt, type setenv auto-boot? true and press
ENTER, so the system will not stop at the OK> prompt after
reset.
d. reset-all
Useful monitor commands
To display various information about the boot HBA:
1. At the OK> system monitor prompt, type select-dev
<controller-path> and press ENTER to select the HBA.
Example: " /pci@1f,4000/QLGC,qla@1" select-dev
2. You can issue any of these commands:
show-boot-id — Prints current boot device ID
version — Prints current version of FCode and firmware
show-connection-mode — Prints current topology
show-adapter-loopid — Prints current adapter-loopId
clear-boot-id — Clears boot-id from the HBA
3. At the OK> prompt, type unselect-dev and press ENTER.
IMPORTANT
!
If you do not want to boot from this HBA again, you must issue the
clear-boot-id command to remove the boot-id from the HBA.