Product guide

36
EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
Installing and Configuring the HBA and Driver
• For the QLA2202FS-E:
./qla2x00fcode -l -p
/devices/sbus@1f,0/QLGC,qla@1,3000:devctl -f
2202fs.prom
• For the QLA2342E-SP:
./qla2x00flash -l
/devices/pci@8,700000/fibre-channel@2:devctl
ifp2312.prom
6. Repeat step 5 for other adapters.
7. Reboot the host with the reconfigure option:
reboot -- -r
8. After the system has rebooted, issue the format command to
verify that the device pathname changed to
QLGC,qla when the
FCode was installed.
The display is similar to this:
Using the SANblade Control FX utility
If you are using the SANblade Control FX utility, proceed from step 4
on page 34 as follows:
5. Open the SANblade GUI:
cd /opt/QLogic_Corporation/SANblade_Control_FX
./scfx
Searching for disks... done
AVAILABLE DISK SELECTIONS:
0. c1t0d0 <SUN36G cyl 24620 alt 2 hd 27 sec 107>
/pci@8,600000/SUNW,qlc@4/fp@0,0/ssd@w21000004cf72febf,0
1. c2t1d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,700000/QLGC,qla@1/sd@1,0
2. c2t1d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,700000/QLGC,qla@1/sd@1,1
3. c3t2d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,700000/QLGC,qla@2/sd@2,0
4. c3t2d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,700000/QLGC,qla@2/sd@2,1
5. c4t3d0 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,600000/QLGC,qla@1/sd@3,0
6. c4t3d1 <EMC-SYMMETRIX-5669 cyl 2148 alt 2 hd 15 sec 64>
/pci@8,600000/QLGC,qla@1/sd@3,1
...