Product guide
Table Of Contents
- Installing and Configuring the HBA and Driver
- Configuring a Boot Device on the EMC Storage Array
Updating the HBA FCode
33
Installing and Configuring the HBA and Driver
Updating the HBA FCode
You can use either of two utilities to update the FCode for an HBA:
◆ qla2x00flash utility
◆ SANblade Control FX utility (only supported for driver 4.13 or
earlier)
Note: Ensure that the QLogic driver has been installed into the system before
updating the HBA FCode.
Both procedures start the same:
1. From the root of your system, create a directory from this list:
2. Copy the appropriate FCode from the QLogic CD or the QLogic
website (as described under “From the QLogic website:” on
page 11), as shown in the following table:
Note: yyy is the FCode version.
HBA model Directory name
QLA2200F-EMC
QCP2202F-E
QLA2200_FCode
QLA2202FS-E QLA2202FS_FCode
QLA2300F-E-SP QLA2300_FCode
QLA2340-E-SP
QLA2342-E-SP
QLA234x_FCode
If HBA is: Copy this FCode file: To this directory:
QLA2200F-EMC
QCP2202F-E
2200FCodeyyy.tar.Z /QLA2200_FCode
QLA2202FS-E 2202sbusFCodeyyy.tar.Z /QLA2202FS_FCode
QLA2300F-E-SP 2300FCodeyyy.tar.Z /QLA2300_FCode
QLA2340-E-SP
QLA2342-E-SP
2312FCodeyyy.tar.Z /QLA234x_FCode