Product guide

28
EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
Installing and Configuring the HBA and Driver
2. Install the SANblade GUI:
pkgadd -d sanbcfx_vnnn
A list of available packages appears.
Example:
Select a package associated with the host Solaris version and
press ENTER.
3. Open the SANblade GUI:
cd /opt/QLogic_Corporation/SANblade_Control_FX
./scfx
4. Double-click the hostname pin located at the upper left of the GUI
to display all QLogic HBAs installed in the host.
5. Click an adapter for which you want to set the variables.
Example: Adapter 2200 (Instance #0)
6. At the Tab dialog, click HBA Options.
7. Under Select Parameter Section:
a. Select Adapter Settings, and set the variables according to
Table 4 on page 21.
When finished, click Save.
b. Select Advanced Adapter Settings, and set the variables
according to Table 4 on page 21.
When finished, click Save.
8. If you are not planning to do the persistent binding for this
adapter, go to step 9.
If you are planning to do the persistent binding for this adapter:
a. Note the following — Persistent binding information added
with the SANblade Control FX utility is placed in a different
part of
/kernel/drv/qla2x00.conf than information added
The following packages are available:
1 scfx2-6 QLogic SANblade Control FX (HBA Configuration Utility)
(sparc) Solaris 2.6, 7 Rev=1.26
2 scfx2-8 QLogic SANblade Control FX (HBA Configuration Utility)
(sparc) Solaris 8-9 Rev=1.26
Select package(s) you wish to process (or ’all’ to process all packages).
(default: all) [?,??,q]: