Product guide

20
EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
Installing and Configuring the HBA and Driver
The persistent binding entry must be in this format:
hbaX-SCSI-target-id-Y-fibre-channel-port-name="PPPP";
where:
•The
X in hbaX is the driver instance number of the HBA. This
instance number corresponds to the instance entry inside the
/etc/path_to_inst.
•The
Y in SCSI-target-id-Y is the device address, as in the
address
/dev/rdsk/c3tYd0s0.
•The
PPPP is the target WWPN of the EMC storage array. On a
Symmetrix console, this information can be found using the e2
command. The output is similar to the following example for
Fibre Channel director port 13B:
The WWPN of Symmetrix Fibre Channel port 13B is
50060482BBFF7A9C.
Editing /kernel/drv/qla2x00.conf
Configuration file qla2x00.conf is created automatically while
installing the HBA driver. The file contains important information
about how the driver should behave. If necessary, edit the
qla2x00.conf file as shown in Table 4 on page 21, which lists the
variables in
qla2x00.conf. Descriptions of the variables follow the
table.
For the changes to the
qla2x00.conf file to take effect, do one of the
following:
◆ If the driver is version 4.13 or earlier, reboot the host.
◆ If the driver is version 4.15.03 or later, issue the command:
/opt/QLogic_Corporation/drvutil/qla2x00
./qlareconfig -d qla2x00
WWN
WWN
HI
LOW
50060482 / 50060482
BBFF7A9C / BBFF7A9C