Product guide

16
EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
Installing and Configuring the HBA and Driver
c. A message describes the driver and prompts you:
Do you want to continue with the removal of this package [y,n,?,q]
Type y and press ENTER.
4. Install the driver as described under “Installing the driver” on
page 12.
5. After the driver is installed, restore any customized parameter
settings in the backup file to
/kernel/drv/qla2x00.conf. (Refer
to step 2.)
6. Edit any necessary files as described under “Configuring host
files” on page 19.
7. Reboot the host with the reconfigure option:
reboot -- -r
Upgrading driver
version 4.05 or 4.06 to
4.07 or higher
Follow these steps to upgrade QLogic driver version 4.05 or 4.06 to
version 4.07 or higher:
1. Log on to the system as a superuser.
2. Back up the appropriate files:
3. Using the SANBlade Control FX GUI utility, record the values of
the following NVRAM parameters for each adapter instance (for
example, adapter 2200 Instance 0):
• max-frame-length
• execution-throttle
• enable-adapter-hard-loop-ID
• adapter-hard-loop-ID
• enable-LIP-full-login
• connection-options
• data-rate (QLA23xx only)
• link-down-error
• link-down-timeout
If HBA is: Back up file:
QLA2200F-EMC
QLA2202FS-E
QCP2202F-E
/kernel/drv/qla2200.conf
QLA2300F-E-SP
QLA2340-E-SP
QLA2342-E-SP
/kernel/drv/qla2300.conf