Product guide

14
EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
Installing and Configuring the HBA and Driver
4. The pkgadd program performs a series of checks, and then posts
a script warning and asks whether to continue the installation.
Example:
Type
y and press ENTER to continue the driver installation.
5. The pkgadd program notifies you when the driver installation is
complete.
When you see the message
Installation of <QLA2x00> was
successful
:
• If the driver is version 4.13 or earlier, reboot the host, and
continue with step 6.
• If the driver is version 4.15.03 or later, continue with step 6.
(No need to reboot the host at this point.)
6. Verify that the HBA’s FCode is installed. To do this, view the
QLogic device pathname in the
/var/adm/messages file or from
the output of the format command:
• If the device pathname contains
QLGC,qla, the FCode is
already installed:
Example:
/ssm@0,0/pci@19,700000/pci@2/QLGC,qla@5
Proceed to step 7.
• If the device pathname contains
fibre-channel or scsi, the
FCode has not yet been installed:
Examples:
/ssm@0,0/pci@19,700000/pci@2/fibre-channel@5
/ssm@0,0/pci@19,700000/pci@2/scsi@5
a. Install the FCode as described under “Updating the HBA
FCode” on page 33.
b. Reboot the host.
c. Proceed to step 7.
7. Edit any necessary files as described under “Configuring host
files” on page 19.
This package contains scripts which will be executed with super-user
permission during the process of installing this package.
_
Do you want to continue with the installation of <QLA2x00> [y,n,?]