User`s guide

3 Connecting a cable

Each connector of the cable has a protrusion which determines the inserting direction

of the connector. When connecting the cable, therefore, check this protrusion to

make sure of the inserting direction of the connector, and then push it in the mating

connector as far as it will go.

・ Push in each connector as far as it will go. The

connector might cause the system to malfunction, if

not inserted properly.

・ Do not put any heavy object on top of the cable, nor

bend it sharply. Install the cables to shat no tension

is applied to it. Otherwise, the cable might cause the

system to fail or malfunction.

・ To disconnect the cable, always pull the connector

but not the cable. Pulling the cable might cause

system failure.

・ This card uses light for communication. So be careful

not to make the ends of its cable dirty.

CAUTION