User`s guide

7 – Setting Up Connections

Viewing Adapter, Device, and Path Information

7-22 FS0054601-00 E

7.3.3

Configure LUN Masking for this Device

You can configure LUN masking—set LUNs as masked or unmasked from the

operating system. Enabling a LUN sets the LUN as unmasked; disabling a LUN

sets the LUN as masked. Use the following options as appropriate:

■ Enabling and disabling all LUNs (see section 7.3.3.1)

■ Enabling and disabling individual LUNs (see section 7.3.3.2)

7.3.3.1

Enabling and Disabling All LUNs

Perform the following steps to configure all LUNs attached to this device as enabled

or disabled:

1. From the LUN Configuration dialog box, right-click in the Enable heading.

2. From the pop-up menu, select one of the following:

❑ Enable All LUNs to configure all LUNs as enabled

❑ Disable All LUNs to configure all LUNs as disabled

❑ Inverse State to enable currently disabled LUNs and disable currently

enabled LUNs

7.3.3.2

Enabling and Disabling Individual LUNs

You can configure a specific LUN as enabled or disabled. In the LUN Configuration

dialog box Enable column, do one of the following:

■ Select the Enable check box to configure the LUN as enabled.

■ Clear the Enable check box to configure the LUN as disabled.

7.4

Viewing Adapter, Device, and Path Information

You can view adapter and device information from the Fibre Channel

Configuration and LUN Configuration dialog boxes. From the LUN

Configuration dialog box, you can also view LUN information.

NOTE: See section 9 for information about viewing host, adapter, device, and

LUN information from the tabbed pages.