User`s guide

7 – Setting Up Connections
Configuring Fibre Channel Devices
7-14 FS0054601-00 E
Q
3. The confirm combining of separated devices message displays. Do one of the
following:
❑ Click No to not combine the separated device.
❑ Click Yes to combine the separated device. The new configuration displays,
as in figure 7-6 for device node name 34-34-34-34-34-34-34-34.
Figure 7-6. Combine Separated Device Configuration
7.2.2
Configuring LUN Path Failover and LUN Masking for this Host
You can configure the following:
■ LUN path failover—set paths as preferred or alternate, and, optionally, current.
■ LUN masking—set LUNs as masked or unmasked from the operating system.
Enabling a LUN sets the LUN as unmasked; disabling a LUN sets the LUN as
masked.
Use the following options as appropriate:
■ Enable or disable failover configuration (see section 7.2.2.1)
■ Load balancing all LUN paths (see section 7.2.2.2)
■ Enabling and disabling all LUNs (see section 7.2.2.3)
■ Configuring LUN paths and LUN masking for a device (see section 7.3)