User`s guide

6 – Getting Started
Setting the Event Log Options
FS0054601-00 E 6-11
Q
4. In the Interval box, type the polling interval. The range is 1 second to
3600 seconds (1 hour). The default is 30 seconds.
NOTE: The faster the polling rate, the more quickly the SANblade Manager
GUI receives indications from the connected host. However, faster
polling rates consume more of your system’s CPU and network
resources and slow the system.
5. Click OK to set the interval. Click Cancel to not change the interval setting.
6.9
Setting the Event Log Options
Perform the following steps to set the number of events the Event Log can list and
the logging of informational and warning events:
NOTE: See section 8.1 for information about viewing the Event Log.
1. On the SANblade Manager main window View menu, select Options. The
Options dialog box displays (see figure 6-9).
Figure 6-9. Options Dialog Box—Event Log Section
2. In the Event Log section Log Size box, type the number of events the Event
Log can list. The range is 20 to 200 events. The default is 20 events.
3. If you want to enable logging of informational events, select the Event Log
section Log Informational Events check box.
4. If you want to enable logging of warning events, select the Event Log section
Log Warning Events check box.
5. Click OK to return to the SANblade Manager main window.