User`s guide

6 – Getting Started
Specifying the Polling Interval
6-10 FS0054601-00 E
Q
❑ Select Ignore Configuration Changes if you want to ignore the
configuration change alarm. The old configuration continues to display. To
update to the current configuration, manually connect and disconnect the
host (see section 7).
3. Click OK to return to the SANblade Manager main window.
6.8
Specifying the Polling Interval
The polling interval is set on a host basis. The polling interval is the length of time
between polls to a connected host to retrieve information. The SANblade Manager
main window HBA tree refreshes automatically based on this rate.
NOTE: If you want to update the HBA tree immediately, click the Refresh button
on the toolbar.
Perform the following steps to set a host’s polling interval:
1. In the SANblade Manager main window HBA tree, select the host (or adapter,
device, or LUN connected to the host) for which you want to set the host’s
polling interval.
2. Do one of the following:
❑ From the Host menu, select Polling.
❑ Right-click the selected host (or adapter, device, or LUN connected to the
host) in the HBA tree. From the pop-up menu, select Polling.
3. The Polling Setting dialog box displays (see figure 6-8). The name of the host
displays in the title bar.
Figure 6-8. Polling Setting Dialog Box