User`s guide

6 – Getting Started
Starting the SANblade Manager GUI
6-2 FS0054601-00 E
Q
6.1.1
Starting SANblade Manager on Windows NT/2000
On a Windows NT/2000 system, do one of the following to start the SANsurfer
application, which includes the SANblade Manager GUI. When done, the SANblade
Manager main window displays (see section 6.2).
■ Double-click the SANsurfer icon on your desktop (if the icon was created during
installation) (see figure 6-1). (If you have an older version of SANblade Manager
and are upgrading to the current version, the old icon image displays.)
Figure 6-1. SANsurfer Icon
■ Click the Start button, point to Programs, point to QLogic Management Suite,
and then click SANsurfer.
■ Click the Start button, click Run, and then do one of the following:
❑ Type in the name of SANsurfer (SANsurfer.EXE), including all the paths. Click
OK.
❑ Click Browse, then select the program after finding it in the Browse dialog
box. Click Open.
6.1.2
Starting SANsurfer on Red Hat Linux or Solaris SPARC
On a Red Hat Linux and Solaris SPARC system, perform the following steps to start
the SANsurfer application, which includes the SANblade Manager GUI. When done,
the SANblade Manager main window displays (see section 6.2).
1. Ensure that you are in a graphical user environment.
2. Open a command terminal.
3. Change to the directory where the SANblade Manager application is installed.
The default location is /opt/QLogic_Corporation/SANsurfer.
4. Type ./SANSurfer and then press ENTER to start the SANblade Manager
GUI.