User`s guide

5 – Installing SANblade Manager
Initial Installation
FS0054601-00 E 5-5
Q
3. The Choose Product Features dialog box displays. The dialog box differs,
depending on whether you are installing on a Windows NT/2000, Red Hat
Linux, or Solaris SPARC system. See figure 5-2 for a sample dialog box.
Figure 5-2. Choose Product Features Dialog Box (Sample)
SANblade Manager supports both stand-alone and network configurations. Do
one of the following to install the software appropriate to your configuration:
❑ Select one preconfigured installation set from the following. Then click Next.
For Windows NT/2000 systems:
❑ Select Both GUIs (Blade/Box) and Agent if you have QLA2xxx adapters
and SANbox2 switches on your system that will be locally or remotely
monitored from other systems on the same network.
❑ Select SANblade Manager GUI if the system will monitor QLA2xxx
adapters only on remote systems on the same network.
❑ Select SANblade NT Agent if the QLA2xxx adapters on this
Windows NT/2000 system will be remotely monitored only from other
systems on the same network.
❑ Select SANblade NetWare 5/6.x Agent if the QLA2xxx adapters on this
NetWare 5/6.x system will be remotely monitored only from other systems
on the same network.
❑ Select SANbox Manager GUI to install the switch application. For more
information, see the SANbox2 Switch Management User's Manual.