User`s guide

5 – Installing SANblade Manager
Initial Installation
FS0054601-00 E 5-3
Q
5.1.2
Installation Instructions
SANsurfer installer is a self-extracting program that installs the SANblade Manager
application and related software.
NOTE:
■ If a previous version of SANblade Manager exists, uninstall it before
proceeding (see section 5.2).
■ You cannot install the SANblade Manager agent directly on a NetWare
server; you must install the agent on a Windows NT/2000 system
connected to the NetWare server. The prerequisites for each NetWare
server are as follows:
❑ A Windows NT/2000 system must be connected to the NetWare server
through the TCP/IP network.
❑ The Windows NT/2000 system must have a drive mapped to the
NetWare server system volume (sys:\).
Perform the following steps to install SANblade Manager on this system or on the
NetWare server connected to this system:
1. Perform the following steps to start the installation:
a. Do one of the following to access the SANsurfer installer:
❑ If you are installing SANblade Manager from the SANsurfer Management
Suite CD-ROM, follow these steps:
❑ Click SANblade HBA Software on the CD-ROM home page.
❑ Find the table that corresponds to your QLogic HBAs (2-Gb Fibre
Channel—2300 Series or 1-Gb Fibre Channel—2200 Series).
Select the appropriate operating system.
❑ Click SANsurfer Management Software.
❑ The File Download dialog box displays. Click Download. Select a
directory on your system and download the file.
❑ If you are installing SANblade Manager from the QLogic Web site, follow
these steps:
❑ From the QLogic home page, click Support.
❑ Click Drivers, Software, and Manuals.
❑ Select your HBA by product or series.
❑ If you selected your HBA by series, click the model number of your
HBA in the table on the right-hand side of the screen.