User`s guide

11 – Updating the Adapter

Updating Adapter Settings

11-6 FS0054601-00 E

■ Hard Loop ID. If the Enable Adapter Hard Loop ID setting is enabled, the

adapter attempts to use the ID specified in this setting. The default ID is 0.

■ Loop Reset Delay. After resetting the loop, the firmware refrains from initiating

any loop activity for the number of seconds specified in this setting. The default

is 5 seconds.

■ Enable Adapter Hard Loop ID. This setting forces the adapter to attempt to use

the ID specified in the Hard Loop ID setting. The default is disabled.

■ Enable Fibre Channel Tape Support. This setting enables FCP-2 recovery.

The default is disabled. This setting applies to the QLA23xx adapter.

11.1.2

Advanced Adapter Settings

To view or modify the advanced NVRAM settings, on the Settings tabbed page

Select NVRAM section box select Advanced Adapter Settings. The Advanced

Adapter Settings section displays the current settings (see figure 11-3).

Figure 11-3. Settings Tabbed Page (Advanced Adapter Settings)