User`s guide

11 – Updating the Adapter
Updating Adapter Settings
FS0054601-00 E 11-3
Q
Perform the following steps to modify the settings for the selected adapter:
1. In the SANblade Manager main window HBA tree, select the adapter.
2. Select the Settings tab.
3. In the Select Settings section box, select the type of settings that you want
to modify.
❑ Adapter Settings. See section 11.1.1 for details.
❑ Advanced Adapter Settings. See section 11.1.2 for details.
4. As appropriate, modify the settings. In the list boxes, type or select the setting.
Select or clear the check boxes.
5. When finished modifying the adapter settings, do one of the following:
❑ Click Save to save the updated settings to the adapter.
The Security Check dialog box displays. In the Enter Password box, type
the password. Click OK.
The save message displays when the changes have been saved to the
adapter:
NOTE: If you modify only the advanced adapter Execution Throttle
setting, the change takes effect immediately. For all other NVRAM
settings, you must reboot the adapter for the changes to take
effect.
❑ Click Current to restore the adapter settings that you previously saved.
❑ Click Initial to restore the adapter settings to their values when the system
was first booted.