User`s guide

10 – Performing Diagnostics
Viewing the Diagnostic Test Results
10-8 FS0054601-00 E
Q
10.4.2
Read/Write Buffer Test Results
The Read/Write Buffer Test Results section provides the following information, as
shown in figure 10-4.
Figure 10-4. Diagnostic Test Results—Read/Write Buffer Test
■ Loop ID/Status
❑ The loop ID of the adapter when operating in loop mode.
❑ The status of the test—whether the test passed or failed. The possible values:
❑ Success. The test passed.
❑ Error. A data miscompare or link status firmware error occurred.
❑ Failed. A link status error, SCSI write buffer error, or SCSI read buffer error
occurred.
❑ Unknown. The target was not present.
❑ Unsupported. The device does not support this test.
■ Data Miscompare. The possible values:
❑ 0 (no data miscompares)
❑ Get link status failed
❑ Read buffer failed
❑ Reserve unit failed
❑ Release unit failed