Installation guide

5 – Windows 2000 Driver Installation QL2200IP NDIS Network Driver Installation
FC0153302-00 D 5-5
5.5.1
Initial Installation of the QL2200IP NDIS Network Driver
Perform the following steps to install the QL2200IP NDIS network driver.
1. Click the Start button on the Taskbar.
2. Select Settings to Control Panel.
3. Select System.
4. Select the Hardware tab, then click Hardware Wizard.
5. Select the Add/Troubleshoot a device radio button.
6. Select Add a new device.
7. Select the No, I want to select the hardware from a list radio button.
8. Select Network Adapters.
9. Insert the diskette that contains the QLogic driver into an appropriate drive
and click Have Disk.
10. Type the path to the QL2200IP NDIS network driver. For example:
A:\W2K\IP
11. Click OK.
12. Select the QLogic QL2200IP Network Driver, then click Next.
13. Click Finish to complete the driver installation.
14. Click OK to close the System dialog box.
15. Select Network & Dial-up Connections in the Control Panel.
16. Right-click the Local Area Connection icon, then select Properties.
NOTE: If your system has multiple Local Area Connection icons, select
the most recent (highest number listed).
17. Make sure the QLA2200 PCI Adapter is listed under Connect using.
18. Click Internet Protocol (TCP/IP), then select Properties. The TCP/IP
Properties dialog box is displayed.