Installation guide

Windows 2000 Installation 5 – Windows 2000 Driver Installation
5-2 FC0153302-00 D
5.3.1
Initial Installation of Windows 2000 and the Windows 2000
Driver
Perform the following steps to install Windows 2000 on the Fibre Channel drive
attached to the QLA22xx board.
1. Insert the Windows 2000 setup diskette or CD (if booting from a bootable
CD-ROM drive) in an appropriate drive.
2. Reboot your system.
3. Follow the standard Windows 2000 installation instructions.
4. Press <F6> to Install Additional Devices.
5. Press s to specify an additional device.
6. Insert the diskette that contains the QLogic driver into an appropriate drive,
then press <ENTER>.
7. Windows 2000 detects the QLogic QLA2200 PCI Fibre Channel Adapter.
Press <ENTER> to continue the driver installation.
8. Press <ENTER> to continue the Windows 2000 installation.
9. Follow the instructions on the screen to complete the Windows 2000
installation.
5.3.2
Installing the Windows 2000 Driver
The QLA2xxx boards are plug-and-play devices that are automatically detected
by Windows 2000. Perform the following steps to add the Windows 2000 driver
to a previously installed Windows 2000 system.
1. Install the QLA22xx board.
2. Power up the computer. Windows 2000 detects the QLA22xx and starts
the Found New Hardware Wizard.
3. Click Next.
4. Select Search for a suitable driver for my device (Recommended). Click
Next.
5. Select SCSI and RAID controllers in the Hardware Types list, then click
Next.
6. Click Have Disk. The Install From Disk dialog box opens.