Installation guide

FC0153302-00 D 4-1
Section 4
Windows NT Driver Installation
(QL2200.SYS)
4.1
Introduction
This section provides instructions for installing the Windows NT driver under the
following operating system conditions:
❑ Initial installation of the Windows NT 4.0 operating system and the
Windows NT driver
❑ Installation of the Windows NT driver in an already installed
Windows NT 4.0 operating system
❑ Installing an updated Windows NT driver in an already installed
Windows NT 4.0 operating system that has an older version of the driver
4.2
Windows NT Driver Files
The latest version of the software drivers and documentation for Windows NT are
available on the QLogic web site. Be sure to review the README.TXT file for
both new and changed information.
4.3
Windows NT Installation
To install Windows NT 4.0 on the Fibre Channel disk that is attached to the
QLA22xx board, perform the installation procedures in section 4.3.1. If
Windows NT 4.0 is already loaded on your system, perform the installation
procedures in section 4.3.2. If Windows NT 4.0 and an older Windows NT driver
are already installed on your system, perform the update procedures in
section 4.3.2.
For information about enhanced scatter/gather in Windows NT, see section 4.3.4.