Installation guide

FC0153302-00 D 3-1
Section 3
NetWare Driver Installation
(QL2200.HAM)
3.1
Introduction
This section provides instructions for installing the NetWare driver in an already
installed Novell NetWare 4.X or 5.X system.
NOTE: References to Novell NetWare versions 4.X or 5.X refer to versions that
are currently supported by Novell.
3.2
NetWare Driver Files and Parameters
The latest versions of the software drivers and documentation for NetWare 4.X
and 5.X are available on the QLogic web site. Be sure to review the README.TXT
file for both new and changed information.
You can load the QL2200.HAM driver with optional switches to customize the
interface between the driver and Novell NetWare. The switches are described in
table 3-1.
3.3
Installing the NetWare Driver
The QL2200.HAM driver may not be compatible with NetWare versions earlier
than 4.X or 5.X.
Table 3-1. QL2200.HAM Driver Parameters
Parameter Description
SLOT = n This switch specifies the PCI slot (slot n) in which the QLA2200
board is installed. The driver should be loaded once for each
QLA2200 board in your system.
/LUNS This switch specifies that all logical unit number (LUN) devices
are scanned after the driver loads. This switch is optional.